Western Digital Ultrastar Data60 User Manual page 155

4. Part Replacement
User Guide
4.9 Chassis Replacement
Figure 167: Installing a Drive Assembly
d. Pinch the latch release and carefully press downward to seat the Drive Assembly the rest
of the way.
Step 38 : Install each drive in the place it was removed from by following the labels or marks that were
added earlier.
Step 39 : If the chassis is being installed into a rack that will be shipped fully assembled, you must install
eight (four per side) of the included M5 x 12mm T15 Flat Head Torx screws into the two brackets
at the front of the chassis in the following locations. These screws should be tightened to
3.38-3.61 Nm / 30-32 in-lbf using a Long T15 Torx Screwdriver. If this chassis will not be installed
into a rack for shipping purposes, skip this step and move on to the next one.
145