User Guide
Required Tools
•
Cable Ties (for
configurations
with greater than
10 total cables)
•
Tape Measure
•
Step 1 : Place the CMA(s) into service position.
a. Unlatch the CMA(s) from the rail at the elbow connector by pressing the blue release
button.
b. Swing the CMA(s) away from the enclosure.
c. The arm(s) should be extended away from the enclosure as shown in the following
example.
Step 2 : Disconnect the Enclosure from power.
•
8mm T10 Torx screws
Level
Figure 132: Unlatching a CMA Connector
Figure 133: CMA(s) in service position (Cables not shown)
Required Parts
Optional (if using
CMA Tray): M3 x
4. Part Replacement
4.9 Chassis Replacement
# of People Required Time Required
123