Western Digital Ultrastar Data60 User Manual page 164

User Guide
a. Unlatch the elbow side of the CMA arm and swing it forward by pressing the blue button
that says "push" to unlatch it.
b. Gather the SAS cables, one power cable, and one Ethernet cable to install in the left hand
side.
c. Open all of the baskets
a. Connect the Ethernet cable to the Ethernet port on the right hand side of the Ultrastar
Data60 and route the cable through each of the baskets on the CMA.
b. Connect the SAS cables and route them through the baskets one at a time. Make sure to
follow the labels to make sure they are connected to the proper port.
c. Connect the power cable to the upper PSU and route it through each basket. The
following image shows the appropriate cable "criss-cross" pattern they should be
installed in.
Figure 181: Open Baskets
4. Part Replacement
4.9 Chassis Replacement
154