Western Digital Ultrastar Data60 User Manual page 28

User Guide
Note: MegaRAID adapters do not support the use of active SAS cables. If your configuration
requires the use of MegaRAID adapters, passive cables must be used.
Table 20: Approved SAS Cables
Active HD Mini-SAS to HD Mini-SAS Variable
Passive HD Mini-SAS to HD Mini-SAS
Passive HD Mini-SAS to HD Mini-SAS
Passive HD Mini-SAS to HD Mini-SAS
Active Cables
During the process of Daisy Chaining the Ultrastar
Data60 enclosures, active cables must be used when connecting between enclosures. The use of
active cables provides improved signal integrity between the enclosures.
Passive Cabling
If you are connecting more than one host port per I/O, you must connect cables to every other port per
IOM and do not need all six ports, Western Digital recommends connecting the cables to every other port
as a best practice. The recommended connection order on IOM A ports A6, A4, and A2 for subsystems
with three or fewer connected hosts. If more than three hosts are required, the recommended connection
order on IOM A ports A5, A3, and A1 to be connected next. The recommended connection order on IOM
B ports B1, B3, and B5 for subsystems with three or fewer connected hosts. If more than three hosts are
required, the recommended connection order on IOM A ports B2, B4, and B6 to be connected next.
* Active Cables can be used for both direct and daisy-chain connections. xx represents the length of the cable and can be
replaced by length of cable in meters; preceding numbers are the qualified cable family.
Type Length
2m, 3m
Part
Number
N/A
CS Electronics: 12G-HD-4444/2M
2m 1EX1531
CS Electronics: 12G-HD-4444-3M
3m N/A
1m,
N/A
1. Overview
1.12 Host Connectivity
Vendor Part Number
Molex: 106415-21xx
*
Amphenol:
601760006
601760006-02
DSC: C5555-2M
FCI: 10117949-2020LF
Molex: 1110751002
TMC: C5555-2M
Amphenol: 601760008
FCI: 10117949-3030LF
Molex: 1110751003
FCI:
10112041-2010LF (1m)
10112041-2020LF (2m)
10112041-2030LF (3m)
18