Western Digital Ultrastar Data60 User Manual page 120

User Guide
b. Use 6 of the included M5 x 12mm screws and the T15 Torx screwdriver to install each
bracket, 3 screws per bracket.
Caution: Always install the top cover onto the enclosure before installing the chassis into a
rack. Not having the top cover installed may damage the alignment brackets.
Step 24 : Install the chassis into the rails.
a. Extend the bearing plates on the inside of the mid-rails until they are fully forward (detent
has engaged). This prevents potential damage due to improper mating of the rails.
Figure 115: Rack Latch Bracket Installed
4. Part Replacement
4.8 Rails Replacement
110