Western Digital Ultrastar Data60 User Manual page 152

User Guide
c. Align the IOM with the empty slot on the top of the chassis so that the arrow on the IOM
latch release is facing toward the side shown in the following image.
d. Slowly lower the IOM into the empty slot while being careful to keep it level. Do not to
force it.
e. When the IOM is lowered fully, apply light pressure with both hands evenly on the IOM
body, not the handles, to seat the IOM in the connector. If the IOM won't seat correctly,
DO NOT FORCE IT. Instead, back the IOM out, check the pins to make sure none are
damaged, and try again.
f. Once the IOM is seated properly in the slot, close the handles until they latch closed.
Step 35 : Install the second IOM using the same method as the first.
Step 36 : Install the IOM Fan.
a. Align the IOM Fan as shown in the following image.
Figure 163: Unlatching IOM Handles
Figure 164: Installing the IOM
4. Part Replacement
4.9 Chassis Replacement
142