Western Digital Ultrastar Data60 User Manual page 109

User Guide
Step 13 : Locate the M5 thumb-screws on the top cover of the enclosure that keep it in place when the
drawer is extended, and unscrew them using a T15 Torx screwdriver. This will allow the top cover
to move freely with the enclosure when the enclosure is removed.
Step 14 : Remove the chassis from the rack.
a. Be prepared to support the enclosure once it is free of the rails by having a second
person or a lift to support the enclosure
b. Grasp both handles at the front of the enclosure and pull with even pressure until the
enclosure will not extend further.
c. Locate the safety catches on the inner rails attached to the enclosure.
Warning: The handles on the front of the chassis are not
intended to be used to support the weight of the Ultrastar Data60.
Lifting the unit by the chassis handles or trying to support the
unit on the handles can cause them to fail. This can cause serious
damage to the unit or serious bodily harm to those handling the
unit. Always team lift the chassis by gripping the underside of the
unit, and never try to lift a chassis that is filled with drives.
4. Part Replacement
4.8 Rails Replacement
99