Western Digital Ultrastar Data60 User Manual page 118

User Guide
b. Use five of the M5 x 12mm T15 Flat Head Torx screws and five of the included washers
and attach the rear cover alignment bracket to the vertical rail with the Long T15 Torx
Screwdriver. Add three M5 x 12mm T15 Flat Head Torx screws and three included washers
to attach the rear rail (the three lower holes) to the rack posts as shown in the following
image. These screws should be tightened to 3.38-3.61 Nm / 30-32 in-lbf using a Long T15
Torx Screwdriver.
Figure 113: Screw and Washer Order
Caution: Be careful to set the screws properly cover alignment
bracket and rail to prevent crossthreading.
4. Part Replacement
4.8 Rails Replacement
108