Cvt Air Filter; Gearbox Oil - BRP CAN-AM OUTLANDER 6x6 2017 Series Operator's Manual

Reinstall muffler cover with new re-
taining screws. Tighten to specifica-
tion.
TORQUE
Tail pipe retaining
screws and
cover retaining
screws

CVT Air Filter

CVT Air Filter Removal
Models with Slip-On Air Filter
1. Remove gauge support.
2. Remove air filter from CVT air inlet
by stretching its sides.
vmo2012-012-042_b
TYPICAL
1. CVT air filter
CVT Air Filter Cleaning
1. Spray filter inside and out with a
good air filter cleaner and follow
manufacturer's instructions.
2. Dry filter completely.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
11 N•m ± 1 N•m
(97 lbf•in ± 9 lbf•in)
______________
vmo2010-004-016_a
1. CVT air filter (slip-on type)
3. Clean inside the CVT air inlet end.
CVT Air Filter Installation
Models with Slip-On Air Filter
1. Install air filter on CVT inlet by
stretching its sides.
2. Reinstall gauge support.

Gearbox Oil

Gearbox Oil Level Verification
NOTICE
necessary. Do not overfill. Operat-
ing the gearbox with an improper
level may severely damage gear-
box. Wipe off any spillage.
Place the vehicle on a level surface.
Select NEUTRAL position.
Apply the parking brake.
Check the gearbox oil level when en-
gine cold, not running, by removing the
gearbox oil level plug.
WARNING
MAINTENANCE PROCEDURES
Check level and refill if
139