GE Senographe DS Operator's Manual page 92

GE Healthcare
Revision 1
Worklist
3-2 Set default configuration
The scanner should already be configured for use with the AWS. If not, configure the scanner to the
default configuration is easy. You simply scan bar code menus.
• Follow the steps below to reset the scanner to the AWS configuration. At each step, read the bar
code provided, using the scanner as described above (section Chapter
symbol). You should hear one or more beeps after each scan:
1. Reset the scanner to the factory settings.
2. Set the default language.
3. Set the default language to English. The scanner must always be set to English for use with the AWS
4. Save the new settings.
• Refer to the scanner documentation for more information on using the scanner.
3-3 Using the scanner for AWS text entry
To enter text in AWS data entry fields using the bar code scanner:
1. Set the cursor in the desired data entry field in the usual way, as if you were about to use the key-
board for text entry.
2. Scan the appropriate bar code symbol as described in section Chapter
symbol. The decoded text appears in the text field just as if you typed it using the keyboard.
Chapter 9
Senographe DS Acquisition System
Page no. 92
Operator Manual 5307907-3-S-1EN
3-1 How to read a bar code
3-1 How to read a bar code
9-worklist.fm