INSTALLATION AND CONNeCTION
3.6.2 To connect C6 SMART with IO modules
•
•
3.6.3 Disconnecting two modules
•
•
Figure 15:
3.6.4 Removing a single module
•
•
After you have snapped the first module (Controller) on the mounting rail, snap
the second module to the right in about 1cm distance to the first module on the
mounting rail.
Push the second module along the mounting rail towards the first module
until you hear the locking device snap in.
Push down the unlock button of the module that you wish to disconnect from the
module to the left of it.
Push both modules away from one another until they are about 1 cm apart.
Disconnecting IO modules
Push the module up and against the metal spring located on the under-side of the
rail guide,
allowing the metal spring to snap in between mounting rail and mounting areas
as illustrated.
Tip the module away from the mounting rail as shown in the illustration.
Pull the module down and out of the mounting rail.
3
31