Installation; Electrical Connection - KEB COMBICONTROL C6 SMART Instructions For Use Manual

Hide thumbs Also See for COMBICONTROL C6 SMART:
Table of Contents

Advertisement

bASIC SAfeTy INSTRUCTIONS

1.3 Installation

DANGeR
EX
To prevent damages to the device:

1.4 electrical connection

DANGeR
For a trouble-free and safe operation, please pay attention to the following instructions:
Do not operate in an explosive environment!
► The device is not intended for the use in potentially explosive envi-
ronment.
Make sure that no components are bent and/or isolation distances are changed.
The device must not be put into operation in case of mechanical defects. There is no
compliance with applicable safety standards any more.
Do not allow moisture or mist to penetrate the unit.
Avoid dust permeating the device. Allow for sufficient heat dissipation if installed in
a dust-proof housing.
Note installation position and minimum distances to surrounding elements. Do not
cover the ventilation openings.
Assembly according to the specified degree of protection.
Make sure that no small parts fall into the device during assembly and wiring (drill-
ing chips, screws etc.). This also applies to mechanical components, which can lose
small parts during operation.
Check the reliable fit of the device connections in order to minimize contact resist-
ance and avoid sparking.
The safety instructions are to be kept!
Voltage at the terminals and in the device !
Danger to life due to electric shock !
► Never work on the open device or never touch exposed parts.
► For any work on the unit switch off the supply voltage and secure it
against switching on.
► Install suitable protective devices for personal protection.
► Never bridge upstream protective devices (also not for test pur-
poses).
► Install all required covers and protective devices for operation.
The electrical installation shall be carried out in accordance with the relevant re-
quirements.
Cable cross-sections and fuses must be dimensioned according to the design of
the machine manufacturer. Specified minimum / maximum values may not be fallen
below /exceeded.
15

Advertisement

Table of Contents
loading

Table of Contents