Damage Due To Overheating; Mounting The Device; Din-Rail Mounting (Snap In); Figure 14: Din-Rail Mounting - KEB COMBICONTROL C6 SMART Instructions For Use Manual

INSTALLATION AND CONNeCTION

3.5 Damage due to overheating

•
•
•

3.6 Mounting the device

3.6.1 DIN-rail mounting (snap in)

•
Figure 14:
30
The operating temperature must be between 0°C and +50°C.
Provide space around the system for air recirculation and heat exchange.
Mounting angle:
a) The system is intended to be mounted vertically.
b) For other installation modes contact KEB.
For installation in control cabinets and, in particular, in closed containers, make
sure the recommended ambient temperature is maintained.
Push the C6 SMART against the mounting rail from below, allowing the metal
spring to snap in between mounting rail and mounting areas as illustrated.
DIN-rail mounting
Push the module against the mounting wall until it snaps in.