Installation And Connection; Selecting The Mounting Location; Select The Mounting Location; Checking The Package Contents - KEB COMBICONTROL C6 SMART Instructions For Use Manual

INSTALLATION AND CONNeCTION

3 Installation and Connection

3.1 Selecting the mounting location

3.1.1 Select the mounting location

•
•
•

3.2 Checking the package contents

•
•

3.3 Checking the operating conditions

•
•
•
•

3.4 Mounting position

The C6 SMART is suitable for installation in:
•
•
•
•
The housing mount consists of an aluminum profile with an integral snap-on device used
to snap the module to a 35mm DIN mounting rail.
Avoid direct sunlight ex-posure.
Make sure that the device is ergonomically accessible to the operator. Select a suit-
able installation height.
Ventilation openings must not be covered.
Check the package content for visible signs of transport damage and for complete-
ness.
In the case of damaged parts, contact your KEB representative. Do not install parts
that were damaged during the shipment.
Read carefully the standards, approvals, EMC parameters and technical specifi-
cations for operation of the device. This information is available in the following
sections:
a) Certificates and approvals.
b) Electromagnetic compatibility .
Check the mechanical and climatic ambient conditions for operation of the device.
Follow the instructions for local use of the device.
Adhere to the permissible rated voltage and the associated tolerance range.
Mounting cabinets
Control cabinets
Switchboards
Consoles
29