Signaling And Diagnostic Leds; Table 4: Led Meaning - KEB COMBICONTROL C6 SMART Instructions For Use Manual

COMMISSIONING Of THe DeVICe

4.2 Signaling and diagnostic LeDs

The following table describes all the LEDs meaning and behaviors.
Name
Operation
PLC status
Bus status
Remote status
Serial status
CAN status
Ethernet status
EtherCAT status
Table 4:
38
Description
Display
• Green, on
• Red, on
• Red BLINK
• Yellow, on
Run/Stop display
• Green, on
• Red, on
• Red BLINK
• Yellow, on
(all LEDs on)
• OFF
Indicates the status of the fieldbus
• Green, on
• Red, on
This LED is activated according to COMBIVIS Connect status.
• Green, on
• Blue ON
It indicates the serial communication activity.
• Green
• Yellow
The 2 LEDs indicate the CAN bus status.
• Green, on
• Red, on
The 2 LEDs are on the RJ45 (10/100/1000 Mbps) connector.
• Yellow/Green
• Green
The 2 LEDs are on the RJ45 (10/100/1000 Mbps) connector.
• Yellow
• Green
LED meaning
C6 SMART and C6 Remote IO module is
ready for operation.
The C6 SMART is not ready for operation.
Typically, that is a temporary status, when
C6 SMART power-up procedure is running
(typical duration 100ms).
The C6 SMART is ready for operation. C6
Remote IO module is not ready for operation
(e.g. too low, because too much current is
drained).
the ultra-capacitors of the micro-UPS are not
charged.
PLC Run
PLC Stop / Breakpoint
PLC stop due to persistent data corruption.
PLC Stopped for Runtime exception.
CONTROL Runtime not running.
Bus OK
Bus Fail.
Device available on domain.
A user is connected via remote access.
RX activated
TX activated
CAN Run
CAN Error
Speed
Link/Act
Unused
Link/Act