Combivis Studio Hmi Project; Overview; Transfer; Configuration Of The Serial Port - KEB COMBICONTROL C6 SMART Instructions For Use Manual

COMMISSIONING A PROjeCT

5.2 COMbIVIS studio HMI project

5.2.1 Overview

Configuration phase
A project includes screen, alarms, variables used to represent the real plant of machine.
The configuration phase is the creation of the project according to the user needs and
interaction between the humans and the machine.
Transferring the project to C6 SMART
You can transfer a project to C6 SMART as follows:
•
•
Process control phase
After the project is transferred, C6 SMART is ready to communicate to one or more
PLCs and to visualize the screens according to the configured project.
Commissioning and re-commissioning
When you switch on the first time C6 SMART, there is no project inside. At first you need
to transfer a project into C6 SMART.
After you have loaded a project, you can transfer back another project or another ver-
sion of the same project (without setting to a special operating mode); this is also possi-
ble while the project is running on C6 SMART.

5.2.2 Transfer

C6 SMART is always ready for accepting the download of a project; even when a project
is running. In this way, if C6 SMART is connected by means of Ethernet to the configu-
ration PC, you are able to download a new project or a new version of the same project
even without stopping the project.

5.2.3 Configuration of the serial port

If your project need to communicate with a device connected to the serial port, you need
to configure the serial port according to the type of serial connection you use for your
communication. The following types of communications are supported by the serial port
of C6 SMART:
•
•
•
Transfer from the configuring PC by using an Ethernet connection.
Copy the project by using a USB key.
If you need to communicate with a device connected to the serial port you must
configure the serial port.
RS 232
RS 422
RS 485
49