Connecting The Serial Port; Managing The Project; Figure 37: Configuration Of The Serial Port; Figure 38: Serial Port Configuration Saved - KEB COMBICONTROL C6 SMART Instructions For Use Manual

COMMISSIONING A PROjeCT
•
Figure 37:
And confirm by pressing the "Apply" button. A warning message will rise, advising to
store that new configuration is active and saved a permanent way.
Figure 38:
Please note that the MPI mode cannot be selected, if this protocol is used by the HMI
software, all necessary settings are applied automatically.

5.2.4 Connecting the serial port

A special DB15 connector supports all serial protocols. Therefore it is necessary to adapt
the connections to the technical requirements; KEB can supply connector adapters as
optional parts but user can adapt DB15 connector by himself.

5.2.5 Managing the project

C6 SMART has powerful tools to manage a running project. With the same mask used
to transfer the project (see below) you can also:
•
•
•
•
Selection of the serial port
Configuration of the serial port
This applet can be used to check which serial communication mode is active.
In this case it is sufficient to click on the red cross in the field on the top right.
Serial Port configuration saved
Stop the C6 SMART project from the configuration PC.
Start the C6 SMART project from the configuration PC.
Debug the project from the configuration PC.
Transfer the project from C6 SMART to the configuration PC.
51