Advanced Navigation GNSS Compass Reference Manual page 58

GNSS Compass Reference Manual • Configuring and Monitoring GNSS Compass
The Factory Reset button resets all GNSS Compass settings back to their factory defaults, including state data
and all configuration settings. It also erases the hot start data so that the system is forced to perform a cold start.
Note: A Factory Reset will re-enable the DHCP Client and lose any static IP address settings.
Figure 31: GNSS Compass Web UI Reset Page
8.1.3.6 Manual Initialisation
This page can be used to manually initialise GNSS Compass when a GNSS fix is not available. Setting the
position will initialise the navigation filter. Setting the heading will also initialise the heading filter.
Figure 32: GNSS Compass Web UI Manual Initialisation Page
8.1.3.7 Ethernet Settings
The Ethernet Settings page allows you to enable or disable the DHCP Client. When the DHCP Client is disabled
you need to enter the TCP/IP settings if you wish to access the web UI.
If you are only connecting to GNSS Compass via the primary port these settings can be ignored.
The default is for the Ethernet mode to be set to DHCP.
v2.0 Page 49 04 Nov 2021