Christie CP2208 User Manual page 46

Field
L/R Display Reference
Frame Rate N:M
L/R Display Sequence
3D Sync Polarity
Dark Time
Output Delay
Phase Delay
11. To activate the channel, select Activate.
CP2208 User Guide
020-101916-03 Rev. 1 (12-20120)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Description
Select Use Line Interleave for 3D source data only. When
specified, the ICP will de-interleave each line into the left
image or right image in memory as specified. Line interleave
can be used with PsF 3D data (left and right data for one field,
then left and right data for second field).
Specifies which frame of eye data to display during a specific
display frame. This signal is referenced to the display frame
rate which is specified by the Frame Rate N:M.
Sets how many frames to display per number of frames that
form one complete image. Increase the display frame rate to
reduce flicker from your source(s).
Defines the frame order (L-R or R-L) required for 3D
perspective. This option only has meaning when the Frame
Rate factor M is equal to 2. For this case, two input frames of
data are required to constitute a complete frame of image
data. This parameter tells the system which frames go
together to make a complete image. When using Line
Interleave as the 3D Sync Input Mode, ensure that Left (L1R1
L2R2) is selected.
Keeps 3D stereo sync output the same as input (true) or
reversed (inverted).
True: 3D L/R sync output from GPO will match L/R sync input.
Inverted: 3D L/R sync output from GPO will be the opposite of
sync input (left = right, right = left).
Creates a blank time interval between left and right frames to
allow for LCD shutter glasses, Z screen, or rotating 3D wheel
to synchronize the output. See Output Delay information
below. Values between 0 and 65535 are accepted. To enter
the dark time value, select the Launch Dialog icon:
The non-image time in Microseconds (μ). Offset 3D stereo
sync output in relation to dark time interval. Acceptable values
are between -32768 and 32767 are accepted where a positive
offset = delay and negative offset = start early. To enter the
output delay value, select the Launch Dialog icon:
The degree of reference between the left and right sync
output. Values between -180 and 180 are accepted. To enter
the phase delay value, select the Launch Dialog icon:
Working with channels
46