Attach Tunnel Wall Assembly - KidKraft BEAR CAVE LODGE Installation And Operating Instructions Manual

Step 53: Attach Tunnel Wall Assembly
A: On the left side of the tunnel wall place 1 (6007) Wall Support beside the (6000) Upper Post. The top of the
(6007) Wall Support should be behind the (6030) Tunnel Side Top and the bottom end should be on the outside of
the (6017) Floor Support. Attach using 1 (H2) ¼ x 2" Hex Bolts (with flat washer, lock washer and t-nut) in tunnel
side and 1 (H3) ¼ x 2-1/2" Hex Bolt in Floor Support. (Fig. 53.1 & 53.2)
B: Repeat step A to install a second (6007) Wall Support on the right side of the tunnel wall. (Fig. 53.1 & 53.2)
C: Measure to ensure that there is a 17" (432mm) space between the 2 (6007) Wall Supports and attach 1 (6014)
Tunnel Spacer flush to the top of the floor boards with 5 (S11) #8 x 2" Wood Screws.(Fig. 53.1 & 53.2)
Fig. 53.1
6000
Wood Parts
2 x Wall Support 31.8 x 76.2 x 1095.4mm
6007
1 x Tunnel Spacer 31.8 x 76.2 x 430.2mm
6014
Fig. 53.2
1/4"
t-nut
6030
6007
6012
6002
6014
flat
washer
Hardware
5 x #8 x 2" Wood Screws
S11
2 x ¼ x 2-1/2" Hex Bolt (with flat washer, lock washer and t-nut)
H3
2 x ¼ x 2" Hex Bolts Hex Bolt (with flat washer, lock washer and t-nut)
H2
104
17" (432mm)
1/4"
t-nut
H2
1/4"
t-nut
x 5
S11
lock
H3
washer
flat
washer
lock
washer
H2
flush to
floor boards
flat
washer
lock
washer
H3