Sand And Water Table Assembly - KidKraft BEAR CAVE LODGE Installation And Operating Instructions Manual

Adventure Tower Assembly
Step 68: Sand and Water Table Assembly
Part 1
A: Place 2 (6015) Box Legs so that the cut outs are on the outside and at the bottom. Place 1 (6004) Box Bottom across the
top of the boards making sure that all top holes line up. Attach with 4 (H2) ¼ x 2" Hex Bolts (with flat washer, lock washer and
t-nut) making sure that the t-nuts are installed into the Box Bottom. (Fig.68.1 & 68.2)
B: Fit 1 (6011) Box Side into the cut outs on each (6015) Box Leg and attach with 1 (H12) ¼ x 3" Hex Bolt (with flat washer,
lock washer and t-nut) per side. (Fig.68.1 & 68.2).
C: From inside the frame place 1 (8832) Box End so that it's pressed up flush to both (6015) Box Legs with the pre-sunk holes
at the bottom and towards the outside (Fig.68.3). Attach with 2 (H1) ¼ x 1-1/2" Hex Bolts (with flat washer, lock washer and
t-nut), 2 (S15) #8 x 1-3/4" Wood Screws and 2 (S4) #8 x 3" Wood Screws as shown in (Fig.68.1 & 68.2).
Fig. 68.1
Fig. 68.2
6004
6015
8832
Wood Parts
6004
2 x Box Leg 23.8 x 82.6 x 444.5mm
6015
2 x Box Side 23.8 x 82.6 x 768.4mm
6011
1 x Box End 23.8 x 82.6 x 362mm
8832
flat washer
lock washer
H2
H12
lock washer
flat washer
H1
1/4"
lock
t-nut
flat
washer
washer
Flush
6011
1/4"
t-nut
1/4" t-nut
H1
S15
Hardware
2 x #8 x 3" Wood Screw
S4
2 x ¼ x 3" Hex Bolt (with flat washer, lock washer and t-nut)
H12
2 x ¼ x 1-1/2" Hex Bolts (with flat washer, lock washer and t-nut)
H1
4 x ¼ x 2" Hex Bolts (with flat washer, lock washer and t-nut)
H2
125
S4
H12
2 x #8 x 1-3/4" Wood Screw
S15