Install Top Back - KidKraft BEAR CAVE LODGE Installation And Operating Instructions Manual

Step 45: Install Top Back
A: On the back side of the assembly install (6028) Top Back using 2 (H8) ¼ x 4-1/4" Hex Bolt (with flat washer,
lock washer and t-nut) in the upper hole and 2 (S7) #12 x 2" Pan Screws in the bottom holes. (fig 45.1 & 45.3)
B: On the left and right Roof Sides install 2 (S20) #8 x 1-3/8" Wood Screws into the bottom holes. (fig 45.1 & 45.2)
C: Install 1 (S20) #8 x 1-3/8"Wood Screw into each pre-drilled hole on the bottom of the (6020) Short Ground and
(6018) Long Ground as shown in (fig. 45.1 & 45.4).
square whole unit up at this time
H4
1-4 x 4 HEX BOLT
w flat washer &
loc washer & T-Nut
X2
Fig. 45.3
1/4" flat
washer
1/4" lock
washer
X2
H8
S15
S7
#8 x 1-3/4" Wood Screw
Short Post Short Post
X4
H8
31.8 x 82.6 x 997mm 31.8 x 82.6 x 997mm
1/4" lock
washer
Fig. 45.4
Top Back
23.8 x 82.6 x 596.9mm
Wood Parts
1 x Top Back 23.8 x 82.6 x 644.5mm
6028
Fig. 45.2
Top Back
23.8 x 82.6 x 644.5mm
Top Back
23.8 x 82.6 x 596.9mm
1/4"
t-nut
Short Post Short Post
31.8 x 82.6 x 933.6mm 31.8 x 82.6 x 933.6mm
1/4" flat
S7
washer
S20
S20
Hardware
8 x #8 x 1-3/8" Wood Screws
S20
2 x #12 x 2" Pan Screws
S7
2 x ¼ x 4-1/4" Hex Bolt (with lock washer, flat washer and t-nut)
H8
94
Fig. 45.1
6028
6018
6023
6020