KidKraft BEAR CAVE LODGE Installation And Operating Instructions Manual page 88

Step 40: Lower Frame Assembly
Part 2
C: Place 1 (6002) Long Post and 1 (6026) Rock Rail side by side with the (6002) Long Post on the right side,
notched end at the top and facing the inside and the (6026) Rock Rail on the left. Make sure that the angled cut on
the (6026) Rock Rail is at the top, facing inwards towards the (6002) Long Post. (Fig. 40.3 & 40.5)
D: From the underside of the assembly place 1 (6017) Floor Support making sure the pre-drilled holes match what
is shown on fig.(Fig. 40.3). Attach using 2 (H3) ¼ x 2-1/2" Hex Bolts (with lock washer, flat washer and t-nuts). (Fig.
40.3 & 40.4)
E: Place 1 (6018) Long Ground across the bottom of both pieces so that it's flush with the ends of the (6002) Long
Post and the (6026) Rock Rail. Attach (6018) Long Ground using 2 (H2) ¼ x2" Hex Bolts (with lock washer, flat
washer and t-nuts). (Fig. 40.3 )
F: On the underside of the (6018) Long Ground place 1 (0369) Lower Diagonal tight and flush to the (6002) Long
Post and the (6018) Long Ground. Attach through (6018) Long Ground with 2 (H2) ¼ x 2" Hex Bolts (with lock
washer, flat washer and t-nut). Pre-drill upper hole of (0369) Lower Diagonal with a 1/8" (3.2mm) drill bit and install
1 (LS3) 1/4 x 3" Lag Screw (with flat washer). (fig. 40.3)
Fig. 40.3
H3
left view
1/4" lock
washer
Fig. 40.4
Wood Parts
1 x Long Post 31.8 x 82.6 x 1968.5mm
6002
1 x Floor Support 31.8 x 82.6 x 875.3mm
6017
1 x Long Ground 15.9 x 114.3 x 1576.1mm
6018
1 x Rock Rail 31.8 x 69.9 x 1827mm
6026
1 x Lower Diagonal 34.9 x 63.5 x 939.8mm
0369
6002
6017
6026
H3
1/4" flat
washer
1/4" t-nut
Fig. 40.5
right view
3 x
2 x
1 x
LS3
1/4" flat
washer
6018
H2
Hardware
1/4 x 2" Hex Bolt (with 1/4" lock washer, 1/4" flat washer and 1/4" t-nut)
H2
¼ x2-1/2" Hex Bolts (with lock washer, flat washer and t-nuts)
H3
¼ x 3" Lag Screw (with flat washer)
LS3
88
H2
1/4" lock
washer
1/4" flat
0369
washer
1/4" t-nut