KidKraft BEAR CAVE LODGE Installation And Operating Instructions Manual page 50

Step 15: Attach Rock Wall Assembly to Fort
Part 2
C: Drive 1 Rebar Ground Stake 13" into the ground against outside (0349) Rock Rail then attach with 1 (S7) #12
x 2" Pan Screw. Be careful not to hit the washer while hammering stake into the ground as this could cause the
washer to break off. (fig. 15.4 and 15.5)
D: After driving stake into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
be driven 13" into ground. Digging or driving stakes can be dangerous if you
do not check first for under-ground wiring, cables or gas lines.
Fig. 15.4
Warning!
To prevent tipping and avoid potential injury, stakes must
0349
Hardware
1 x #12 x 2" Pan Screw
S7
50
Fig. 15.5
Other Parts
1 x Rebar Ground Stake
0349
S7
Rebar
Ground
Stake