Attach Tnr 4 Slide To Adventure Tower - KidKraft BEAR CAVE LODGE Installation And Operating Instructions Manual

Step 80: Attach TNR 4 Slide to Adventure Tower
A: On the fourth attached Elbow Assembly remove the pan bolt and nut which is facing the tower (installed previously
Step 73). (fig. 80.2) The bolt will no longer be needed, but keep the lock nut.
B: Loosely attach TNR3 Tube Support (at the slightly bent end) to the slide seam using 1 (PB6) 1/4 x 1" Pan Bolt (with
flat washer and the previously removed lock nut). (fig. 80.1)
C: Rotate TNR3 Tube Support and attach to (6002) Long Post using 1 (S6) #12 x 1" Pan Screw as shown in (fig. 80.1.)
D: Fully tighten screw and bolt.
Fig. 80.1
6002
Note: Flat
end down
Remove PB1 (1/4 x 3/4"
Pan Bolt) first then install
PB6 (1/4 x 1" Pan Bolt
with flat washer)
TNR3 Tube
Support
Lock
Nut
PB6
S6
1 x #12 x 1" Pan Screw
S6
1 x 1/4 x 1" Pan Bolt
PB6
(1/4" flat washer & 1/4" lock nut - previously removed)
Flat
Washer
Hardware
142
Fig. 80.2
6002
TNR Brace
Assembly
Other Parts
1 x TNR3 Tube Support