Attach Elbow Assemblies And Tnr4 Slide - KidKraft BEAR CAVE LODGE Installation And Operating Instructions Manual

Step 81: Attach Elbow Assemblies and TNR4 Slide
A: Place TNR Brace centered over pilot holes of AL-RW Ground Brace. Attach with 3 (S4) #8 x 3 Wood Screws. (fig. 81.3)
B: Place 1 TNR4 Post Mount Clamp on either side of the Clamp Ring so that the bent tops clip in behind the Clamp Ring.
C: Insert the TNR4 Post Mount Base in between the 2 TNR4 Post Mount Clamps and bolt all pieces together using one ¼
x 14.5mm Pan Head Bolt and Square Lock Nut. (fig. 81.2)
D: Attach TNR4 Post Mount Base to (8965) TNR Upright, pre-drill with a 1/8" (3.2mm) drill bit then attach with 2 (S6) #12 x
1" Pan Screws. (fig. 81.2)
E: Attach the Post Mount Clamp to the clamp ring using 1 (S37) #7 x 5/8" Pan Screw. (fig. 81.2)
Fig. 81.1
Fig. 81.2
¼ x 14.5mm
Pan Head Bolt
TNR4 Post
Mount Base
Fig. 81.3
Hardware
2 x #12 x 1" Pan Screw
S6
3 x #8 x 3" Wood Screw
S4
1 x #7 x 5/8" Pan Screw
S37
143
S37
S6
100
6021
S4
TNR4 Post
Mount Clamp
Square
Lock
Nut
8965
8963
Other Parts
2 x TNR4 Post Mount Clamp
1 x TNR 4 Post Mount Base
1 x 1/4 x 14.5 mm Pan Head Bolt
1 x Square Lock Nut