Lower Frame Assembly - KidKraft BEAR CAVE LODGE Installation And Operating Instructions Manual

Step 40: Lower Frame Assembly
Part 1
A: Place 1 (6002) Long Post and 1 (6026) Rock Rail side by side with the (6002) Long Post on the left side
making sure that the notched out end is at the top and on the inside. It is important to ensure that the angled cut
on the (6026) Rock Rail is at the top, facing inwards towards the (6002) Long Post. Place 1 (6020) Short Ground
across the bottom of both pieces so that it's flush with the ends of the (6002) Long Post and the (6026) Rock
Rail. Attach using 2 (H2) ¼ x 2" Hex Bolts (with lock washer, flat washer and t-nuts). (Fig. 40.2)
B: From the underside of the assembly place 1 (6017) Floor Support making sure the pre-drilled holes match
what is shown on fig.(Fig. 40.2). Attach using 2 (H3) ¼ x 2-1/2" Hex Bolts (with lock washer, flat washer and
t-nuts). (Fig. 40.1 & Fig. 40.2)
Fig. 40.2
add 1/4" T-Nut to inside
of Long Post
H2
1/4" lock
washer
Flush
1/4" t-nut
Wood Parts
1 x Long Post 31.8 x 82.6 x 1968.5mm
6002
1 x Floor Support 31.8 x 82.6 x 875.3mm
6017
1 x Short Ground 15.9 x 114.3 x 1122mm
6020
1 x Rock Rail 31.8 x 69.9 x 1827mm
6026
D
1/4" flat
washer
6002
6020
H2
Flush
1/4" t-nut
Fig. 40.1
H1
1/4" lock
washer
1/4" flat
washer
H3
1/4" lock
washer
1/4" flat
washer
1/4" t-nut
6017
6026
1/4" lock
washer
1/4" flat
washer
Hardware
2 x 1/4 x 2" Hex Bolt (with 1/4" lock washer, 1/4" flat washer and 1/4" t-nut)
H2
2 x ¼ x 2-1/2" Hex Bolts (with lock washer, flat washer and t-nuts).
H3
87
add 1/4" T-Nut to inside
of Long Post
1/4" t-nut
H3
1/4" lock
washer
1/4" flat
washer
1/4" t-nut
square each sub assembly
2 angles shown, pick the best one