Attach Ground Stake To Tnr Upright - KidKraft BEAR CAVE LODGE Installation And Operating Instructions Manual

Step 82: Attach Ground Stake to TNR Upright
A: In the spot shown in (Fig. 82.1) drive 1 Rebar Ground Stake 13" (330mm) into the ground against the
(8965) TNR Upright. Be careful not to hit the washer while hammering stake into the ground as this could
cause the washer to break off.
B: Attach the ground stake to (8965) TNR Upright just below the t-nut using 1 (S7) #12 x 2" Pan Screw as
shown in (Fig. 82.2).
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth
any sharp edges from impact area and touch up with outdoor paint.
Fig. 82.1
Warning! To prevent tipping and avoid potential
injury, stakes must be driven 13" (330mm)
into ground. Digging or driving stakes can be
dangerous if you do not check first for under-
ground wiring, cables or gas lines.
Hardware
1 x #12 x 2" Pan Screw
S7
144
T-Nut
Fig. 82.2
8965
13" In Ground
(330mm)
SEE FRONT COVER FOR
SAFETY CLEARANCE
•See details
S7
Rebar
Ground
Stake
Other Parts
1 x Rebar Ground Stakes