Connecting The Power And The Host Pc - ICPDAS ECAT-2610 User Manual

EtherCAT to Modbus RTU Gateway

3.2 Connecting the Power and the Host PC

Step 1
Connect both the IN port of ECAT-2610 module and RJ-45 Ethernet port
of Host PC.
Ensure that the network settings on the Host PC have been correctly configured and are functioning
normally. Ensure that the Windows firewall or any Anti-Virus firewall is properly configured to allow
incoming connections, or temporarily disable these functions.
NOTE
Attaching an ESC (EtherCAT Slave Controller) directly to an office network will result in network flooding, since the ESC
will reflect any frame – especially broadcast frames – back into the network (broadcast storm)
Step 2
Apply power to the ECAT-2610 module
Connect the Host device to the

IN Port on ECAT-2610 module.
Copyright © 2017 ICP DAS CO., Ltd. All Rights Reserved.
Connect the PWR(+) pin to positive

terminal on a +12 ~ +48 V
supply, and connect the GND(-) pin to
the negative terminal.
Figure 3-2.1
.
power
DC
- 16 -