Configuring And Uploading - ICPDAS ECAT-2610 User Manual

EtherCAT to Modbus RTU Gateway

4.2 Configuring and Uploading

Step 1
Connect the Download Cable to the Host PC.
Connect the COM1 of ECAT-2610 to COM Port of Host PC using the CA-0915
download cable.
Step 2
Download the ECAT-2610_Utl_xxxxxx.zip.
After decompressing ECAT-2610_Utl_xxxxxx.zip, including "ECAT-2610 configuration Tool.exe" and
"7188ECAT folder", they are configuration and diagnostic utility that can be obtained either from
the companion CD or ICP DAS web site at:
CD:\Napdos\ECAT-2000\Software\
http://ftp.icpdas.com/pub/cd/fieldbus_cd/ethercat/slave/ecat-2000/software/
After all the software is copied to the Host PC (e.g., E:\), the content of 7188ECAT folder should be
as follows:
Copyright © 2017 ICP DAS CO., Ltd. All Rights Reserved.
Configuration files Reference for DI, DO, AD, DA ... etc. Refer to
Section A2. "Configuration Files Reference"
Execution file
Control file for 7188ECAT.exe
Configuration file. The ECAT-2610 will communicate with the Modbus
RTU slave device through this file.
Using COM1 of Host PC to upload the configuration file to ECAT-2610
Using COM2 of Host PC to upload the configuration file to ECAT-2610
CA-0915 Cable
for more detail.
Figure 4-2.1
- 26 -