ICPDAS ECAT-2610 User Manual page 97

EtherCAT to Modbus RTU Gateway
Step 4
Set the delay time in the end of command.
Command
Description
0 This parameter is used to set the delay time. Settings Range: 0 ~ 255 ms
0 0 0 0 0 These parameters are reserved and have no function.
Step 5
Set the number of Modbus commands.
Command
Description
This parameter is used to set the number of Modbus commands listed below.
1
Settings Range: 0 ~ 200 (Max.)
Copyright © 2017 ICP DAS CO., Ltd. All Rights Reserved.
Figure A3-3
Figure A3-4
- 97 -