Table of Contents
Advertisement
EtherCAT to Modbus RTU Gateway
4. The "ECAT-2610 CFG TOOL" dialog box is displayed again asking you to reboot the ECAT-2610
module when the upload is successful.
5. Power off and power on the ECAT-2610 module and click the "OK" button to complete the
upload.
Figure 4-2.9
Note:
If the upload configuration via ECAT-2610 configuration tool.exe is failed, then the manually configuration file
and upload is required to make the module working again, refer to
more detail.
Copyright © 2017 ICP DAS CO., Ltd. All Rights Reserved.
A3. "Manually Configure and upload"
for
- 31 -
Advertisement
Table of Contents
