Table 10-1. T1 Trunk Conditioning Service Options; Activate Map - ADTRAN Atlas 550 User Manual

Chapter 10. Dedicated Maps
Option
T1 Trunk Conditioning State Defines the final fault signaling state as follows:
T1 Fault Signaling (AB/AB)
T1 Trouble Code Value
T C
O ONFIG
SIG
A T
CTIVATE IME
E D
NBL AY
10-6
Table 10-1 describes the options for T1 T

Table 10-1. T1 Trunk Conditioning Service Options

I is used for one-way trunks; that is, for outgoing or incoming
DLE
calls, but not both.
S is used for two-way trunks. It prevents the PBX from
EIZED
attempting to use a failed trunk for an outgoing call.
This option is not included for C
Defines to the ATLAS 550 the signaling bits being used on the trunk.
Fault signaling is only visible when RBS is turned on.
Defines to the ATLAS 550 the value to set in the data field for
outgoing DS0s when a trouble condition exists.
Write security: 3; Read security: 5
Specifies the configuration for the T
play in this field are based on the type of module selected in the TO S
option. See From Config on page 10-4 for a description of these settings.
Write security: 3; Read security: 5
(Signaling) Defines whether the connection has active RBS. Where RBS is
not an option, the ATLAS 550 automatically assigns the correct setting. For
example, a T1-to-Nx connection is set to
RBS Preserves the signaling bits between the connections.
O Ignores signaling bits.
FF
Write security: 3; Read security: 5
Sets the time when the map becomes active if you have selected A
A M field (see Activate Map on page 10-2). Enter this time in
CTIVATE AP
hh:mm:ss 24-hour format.
Write security: 3; Read security: 5
Specifies which days of the week the map is active.
ATLAS 550 User Manual
C
RUNK ONDITIONING
Description
.
USTOM
connection. The selections that dis-
O
.
Off
.
S
ERVICE
LOT
in the
UTO
61200305L1-1