Figure C-1. Atlas To Support Packet Data Configuration - ADTRAN Atlas 550 User Manual

Appendix C
EXAMPLE 1:
61200305L1-1
Frame Relay Examples
This chapter provides step-by-step examples to help you configure your AT-
LAS 550 for frame relay. Figure C-1 illustrates an ATLAS 550 configured to
support packet data.
Nx
Port
Router
Nx
Port
SNA Router

Figure C-1. ATLAS to Support Packet Data Configuration

The general procedure for configuring the ATLAS 550 depicted in Figure C-1
is as follows:
1. From P
M
ACKET ANAGER
endpoints.
2. From P M
ACKET ANAGER
connections.
From D M
EDICATED AP
IP ROUTING NETWORK—ATLAS 550 AS THE
CENTRAL-SITE ROUTER
Example 1 (see Figure C-2 on page C-2) depicts a typical IP routing network
using an ATLAS 550 as the central-site router. A TSU 100e with a router
module is located at each of the two remote sites, and an FSU with an
external router is located at a third site. The central-site ATLAS 550
terminates a full T1 frame relay connection from the XYZ service provider,
and the internal router terminates the IP traffic. To re-create this example,
follow the process that follows.
ATLAS 550 User Manual
Pkt
Endpoint 2
IP
Pkt
Endpoint 1
SNA
Pkt
Endpoint 3
/P
E
ACKET NDPNTS
/P C , make the IP and SNA protocol
ACKET NCTS
, connect the packet endpoints to the physical ports.
ATLAS 550
T1
Frame Relay
Port
Network
/C , create three packet
ONFIG
C-1