Table 2-7. Network Interface 15-Pin Male D-Connector Pinout; Test Interface; Frame Relay Specifications - ADTRAN Atlas 550 User Manual

Chapter 2. Installation

Test Interface

Frame Relay Specifications

2-8
Connector type 15-pin Male D-connector
Part number AMP# 74784-12

Table 2-7. Network Interface 15-pin Male D-connector Pinout

PIN NAME
1 T TXDATA-TIP
2 UNUSED
3 T1 RXDATA-TIP
4, 5, 6, 7 UNUSED
8 FG FRAME GROUND
9 R TXDATA-RING
10 UNUSED
11 R1 RXDATA-RING
12, 13, 14 UNUSED
15 FG FRAME GROUND
The N and O
I
ETWORK N UT
for the incoming T1. By connecting test equipment to these jacks, the T1 con-
nection breaks and the test equipment terminates the incoming T1. The MON
and O Bantam test jacks provide a bridged access jack for nonintrusive
I
N UT
monitoring of the incoming T1. When connected to this jack, configure the
test equipment for bridged termination.
• Packet throughput at 4000 pkts/sec
• Management signaling interfaces
- UNI (user-to-network interface)
- NNI (network-to-network interface)
• Management signaling types
- ANSI T1.617-D (Annex D)
- ITU-T Q.933-A (Annex A)
- LMI (Group of four)
- Auto
• Encapsulation - RFC 1490 for IP and LLC2
• PVC support - 300 PVCs
ATLAS 550 User Manual
Transmit data toward the network
Receive data from the network
Grounded to chassis
Transmit data toward the network
Receive data from the network
Grounded to chassis
Bantam test jacks provide intrusive test capability
DESCRIPTION
61200305L1-1