ADTRAN Atlas 550 User Manual page 48

Chapter 3. Operation
3-2
Instructions for Setting Up an ATLAS 550 for VT-100 Terminal Mode
Step
1 Set the baud rate on the VT-100 terminal to 9600 baud (8/N/1).
Use the ADTRAN-provided VT-100 terminal adapter to connect
the COM port of a VT-100 compatible terminal, or equivalent, to
the eight-pin modular jack labeled
2
rear panel or labeled CRAFT on the front panel.
This connection provides both local and remote configuration.
Press Enter repeatedly on the keyboard until the L
3
requiring a password appears.
4 Press Ctrl-R to refresh the display, if necessary.
When you begin the VT-100 session, you will be prompted for a password.
The default password is password (which is a Level 0 superuser password).
You can change this password using the A
is only accessible through the terminal menu. See Access Passwords on page
6-15 for details. After your password is accepted, define the IP Address of
the ATLAS 550 to which you want to connect. The following Step/Action
chart describes this process.
Instructions for Defining the IP Address
Step
Obtain an IP address for the ATLAS 550 from your LAN
1
administrator.
Use the ADTRAN-provided VT-100 terminal adapter to connect
the COM port of a VT-100 compatible terminal, or equivalent, to
the eight-pin modular jack labeled CONTROL/CHAIN IN on the
2
rear panel or labeled CRAFT on the front panel.
This connection provides both local and remote configuration.
Press Enter repeatedly on the keyboard until the L
3
appears. Enter your password.
When the terminal menu opens, navigate the following path:
4
ATLAS 550 / S
5 Key in the entire IP address, and then press Enter.
You will need a default gateway if the LAN contains multiple
segments. Contact your LAN administrator for the appropriate
address.
ATLAS 550 User Manual
Action
CONTROL/CHAIN IN
CCESS
Action
C / E
YSTEM ONFIG THERNET PORT
on the
menu
OGIN
P option, which
ASSWORDS
menu
OGIN
/ IP A
DDRESS
61200305L1-1