Table of Contents
Advertisement
11
Saving the Configuration
1.
Verify that the prompt of your module displays (config)#.
2. Enter exit to close the configuration session.
3. Enter copy running-config startup-config to save the current configuration to memory.
4. Enter exit to close the session.
12
Complete the Installation
The TSU NetVanta Router Module is now configured and operational. Complete the installation by connecting the
appropriate cables to the Ethernet network. Refer to Step 2, Reviewing the Module Design for more details on
pinouts and cabling.
13
Testing Options
The execution of Port Tests disrupts normal data flow to the port under test.
The TSU NetVanta Router Module provides several test features (through the TSU/ESU front panel only) for
testing the connection between the module and the base unit (the serial interface).
Port/Local Loopback with Test Pattern
The TSU NetVanta Router Module port loopback activates both a local loopback (back towards the TSU NetVanta
Router Module) and a port loopback (towards the TSU/ESU base unit) when evoked (see figure bellow). Using this
loopback verifies the connection between the TSU NetVanta Router Module and the TSU/ESU base unit.
The following steps initiate a remote loopback of the Router Module "serial" interface:
1.
From the remote TSU front panel select
P
2. Enter the
ORT
You must enter your valid passcode to proceed with the rest of the test.
N
3. Select the
X
1 DTE L
4. Select
L
(or
OOPBACK
T
menu by pressing
EST
/DBU
R
or
port to enter the tests mode.
OUTER
by pressing
OOPBACK
R
V.54C
for the TSU NetVanta Router Module).
EM
ONT
4 T
4
by pressing
then
EST
3
E
then
.
NTER
1
E
then
. Use the up and down arrows to choose
NTER
11
E
.
NTER
R
EMOTE
Advertisement
Table of Contents
