Dial On Offhook; Source Id; Dual Nx56/64 Module: User Termination - ADTRAN Atlas 550 User Manual

Chapter 11. Dial Plan
S ID
OURCE
D O
IAL ON FFHOOK

DUAL NX56/64 MODULE: USER TERMINATION

11-22
S MSD does not affect C
TRIP
(including the MSDs that are subsequently stripped) are used as
accept criterion.
Write security: 3; Read security: 5
Simplifies the creation of a D
switching calls to a certain endpoint is a function of which endpoint origi-
nated the call.
• Default value = 0. The default ID for all endpoints is 0 and all accept
numbers is 0. With default values, all calls are routed based only on the
dialed number.
• Multiple endpoints can have the same S
• When creating the C
dialed number or range of dialed numbers to accept.
Example:
An application requires that all calls that originate from Port 1 of the
ATLAS 550 in Slot 1 be switched to Port 2 of that same module. Assign a
unique Source ID (e.g. 7) to Port 1 of the module, and then configure Port 2
to only accept calls from that unique Source ID (7).
Write security: 3; Read security: 5
Defines a number that is automatically sent to the switchboard when a call
on this endpoint goes off hook.
The Dial on Offhook number must be specific (i.e., no "wild cards").
The Dual Nx56/64 can only serve as a U
endpoint.
When you are working in the U
the S is defined as V35N
LT
are available:
ATLAS 550 User Manual
A
ALL CCEPT
in applications where the criterion for
P
IAL LAN
OURCE
A list, specify a S
ALL CCEPT
T section of the D
SER ERM
-2, the following Interface Configuration options
X
criteria. All of the digits
ID.
ID(s) as well as a
OURCE
T
SER ERMINATION
P menu, and
IAL LAN
61200305L1-1