Reject Number - ADTRAN Atlas 550 User Manual

Chapter 11. Dial Plan
D 64K,
ATA
D 56K,
ATA
A , S
UDIO PEECH
T C A
REAT ALL S
O #R
UT EJ
R N
EJECT UMBER
D 56K,
ATA
D 64K,
ATA
A , S
UDIO PEECH
I C
FCE ONFIG
11-8
S S
ECONDARY EARCH
The same accept rules apply for all secondary number searches as for pri-
mary searches.
Write security: 3; Read security: 5
Reflects the attached user equipment (typically a TA) bearer capability. If
the attached TA can only handle digital calls, then a voice call sent to this
endpoint would be rejected.
Allows the incoming call to be treated as the selected call type, regardless of
the actual incoming call type. The default selection, A
tively disables the feature by using the actual call type. Other options
include D 64K and D
ATA
Write security: 3; Read security: 5
Defines the parameters for outgoing calls that ATLAS 550 will not send to
the Network.
Designates which numbers this particular endpoint will not pass on toward
the Network (PSTN). Use when the outgoing call filter is different for differ-
ent users. The wild cards are identical to the O
cards. If desired, each User termination port can be set to reject different
numbers.
[0,1]-$ rejects all long distance calls, but only for this User
termination. If permitted in the Network termination endpoint, this
user could not dial long distance numbers while other users could.
Rejects outgoing calls based on call type. For example, setting the reject
number to $, Digital 56/64 to enabled, and Audio and Speech to disabled,
rejects all digital calls while not rejecting analog calls.
This list may remain blank if the Accept List meets desired filtering.
The Call Reject list takes precedence over the Call Accept list.
Sets configuration parameters for the endpoint. These parameters vary by
the type of port selected. For detailed information on the interface configu-
ration, see Interface Configurations on page 11-10.
ATLAS 550 User Manual
56K.
ATA
UTGOING
, effec-
R
S ECEIVED
C A wild
ALL CCEPT
61200305L1-1