P
A
ORTS
VAILABLE
N
P
UMBER OF
ORTS
N
D
UMBER TO
IAL
C
T
ALL
YPE
D
C
A
IAL
ALL
S
D
IGITAL
V
OICE
A
UDIO
S
ID
OURCE
61200305L1-1
Indicates which of the two ports of the ATLAS 550 have already been
defined either in another switched endpoint (indicated by
M
(indicated by
CATED
AP
Defines to the ATLAS 550 how many of the ports could be used to answer
calls to the number(s) defined in the I
enter numbers 1 or 2. The ports are contiguous beginning with the port
number selected and the number of ports.
Example:
If the port selected (as a part of the S
ber of ports selected here was 1, then only port 2 would be enabled to
receive calls to the numbers listed under the I
Indicates the number to be dialed.
Indicates whether the call will be 64
use in applications where interoperability with S
sired. 64
is the default call type.
K
Indicates how the call will be handled over the network: D
Requests a 56 kbps data circuit that is rate-adapted to 56 kbps or an unre-
stricted 64 kbps data circuit.
Requests a Mu-law/A-law speech circuit as the bearer capability for outgo-
ing calls. Use V
with an ISDN line configured for voice service. In some
OICE
areas, voice service costs less than data service. A V
guarantee an end-to-end digital connection with some local and long dis-
tance carriers.
Requests a 3.1 kHz audio circuit as the bearer capability for outgoing calls.
Use A
with an ISDN line configured for voice service. In some areas
UDIO
audio service is less expensive than data service. An A
antees a digital end-to-end ISDN connection.
Simplifies the creation of a D
switching calls to a certain endpoint is a function of which endpoint origi-
nated the call.
•
Default value = 0. The default ID for all endpoints is 0 and for all accept
numbers is 0. With default values, all calls are routed based only on the
dialed number.
•
Multiple endpoints can have the same Source ID.
•
When creating the Call Accept list, specify a Source ID(s) as well as a di-
aled number or range of dialed numbers to accept.
Example:
An application requires that all calls that originate from Port 1 of the
ATLAS 550 in Slot 1 be switched to Port 2 of that same module. Assign a
unique Source ID (e.g. 7) to Port 1 of the module, and then configure Port 2
to only accept calls from that unique Source ID (7).
ATLAS 550 User Manual
). This field is read-only.
N
A
NCOMING
CCEPT
/P
selection) is 2, and the num-
LOT
ORT
NCOMING
or 56
data rate: 56
K
K
WITCHED
in applications where the criterion for
P
IAL
LAN
Chapter 11. Dial Plan
) or in a D
-
S
EDI
. You can
C
L
ALL
IST
.
C
A
L
ALL
CCEPT
IST
is intended for
K
56 service is de-
, V
, or A
.
IGITAL
OICE
UDIO
call type does not
OICE
call type guar-
UDIO
11-23