Camshaft/Rocker Arm; Installation - Honda SH300 2006 Manual

Table of Contents

CAMSHAFT/ROCKER ARM

CAMSHAFT/ROCKER ARM INSTALLA-

Apply molybdenum oil solution to the sliding sur-

Do not exchange

face of the rocker arms and shafts.

the intake and

exhaust rocker arm

Clean the rocker arm shaft holes and camshaft bear-

ing mating area.

Install the rocker arms and side springs as shown.

Install the rocker arm shafts to the cylinder head.

Install the rocker

arm shafts with the

cut-out facing rear

Apply molybdenum oil solution to the camshaft

bearing and cam lobes.

Install the camshaft with the cam lobe facing the

cylinder side while pressing down on the valve side

of the rocker arm.

Apply locking agent to the stopper plate bolt

threads (page 1-16).

Install the stopper plate, stopper bolt to the cylinder

head as shown and tighten the bolt to the specified

TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)

CYLINDER HEAD/VALVES

STOPPER PLATE

Table of Contents