Delay Valve (Abs Type) - Honda SH300 2006 Manual

HYDRAULIC BRAKE
INSTALLATION
Install the delay valve and tighten the delay valve
mounting bolts.
Connect the brake hoses to the delay valve with the
oil bolts and new sealing washers.
Tighten the brake hose oil bolts to the specified
torque while setting the hose joints against the
stoppers on the delay valve.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Apply clean brake fluid to the brake pipe joint nut
thread.
Install the brake pipe to the delay valve and tighten
the joint nut to the specified torque.
TORQUE: 14 N·m (1.4 kgf·m, 10 lbf·ft)
Fill brake fluid and bleed air the hydraulic system
(page 17-7).
Install the front upper cover (page 3-9).

DELAY VALVE (ABS TYPE)

REMOVAL
Remove the following:
– front upper cover (page 3-9)
– front handlebar cover (page 3-14)
– rear handlebar cover (page 3-14)
– front inner cover (page 3-10)
Drain the brake fluid from the hydraulic system
(page 17-7).
Loosen the joint nut and disconnect the brake pipe
Be careful not to
from the delay valve.
damage the brake
pipe.
Remove the oil bolt, sealing washers and discon-
When removing the
nect the brake hose.
brake pipe joint
nuts, cover the end
Remove the delay valve mounting bolts and delay
of the pipes to pre-
valve.
vent contamination.
17-26
JOINT NUT
OIL BOLTS/
SEALING WASHERS
BRAKE PIPE
DELAY VALVE
BRAKE PIPE
OIL BOLT SEALING WASHERS
BOLTS
BOLTS
JOINT NUT
DELAY VALVE