Honda SH300 2006 Manual page 160

FUEL SYSTEM (PGM-FI)
INSTALLATION
Place a new packing onto the fuel tank and apply
Always replace
less than 1.0 g of engine oil to lip surface of the
packing with a new
packing.
one.
Install the fuel pump unit to the fuel tank.
• Be careful not to damage the fuel level sensor
when installing the fuel pump unit.
• Be careful not to allow the dirt and debris
between the fuel pump and packing.
Install the set plate by aligning the allow marks and
its holes with the tabs on the fuel pump unit.
• Be careful not to damage the pipe end when
installing the set plate.
Install and tighten the fuel pump mounting nuts in
the sequence shown.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
6-50
LIP SURFACE
PACKING
FUEL PUMP UNIT
Align (tab/hole)
Align (allow marks)
SET PLATE