Honda SH300 2006 Manual page 294

ALTERNATOR/STARTER CLUTCH
Install the starter clutch assembly onto the flywheel.
Clean the starter clutch socket bolt threads.
Apply locking agent to the socket bolt threads.
Align the bolt holes on the starter clutch outer and
flywheel.
Install the socket bolts.
Hold the flywheel with the special tool and tighten
the six starter clutch outer socket bolts to the speci-
fied torque.
TOOL:
Flywheel holder
TORQUE: 23 N·m (2.3 kgf·m, 17 lbf·ft)
Apply molybdenum oil solution to the starter driven
gear inner surface.
Apply engine oil to the starter driven gear boss
outer surface and gear teeth.
Install the starter driven gear into the starter clutch
on the flywheel while turning it clockwise.
Check that the starter driven gear turns clockwise
smoothly and does not turn counterclockwise.
INSTALLATION
Install the woodruff key in the crankshaft key
groove.
Apply molybdenum oil solution to the starter driven
gear sliding surface of the crankshaft.
13-12
STARTER CLUTCH ASSEMBLY
FLYWHEEL
07725-0040001
FLYWHEEL HOLDER
BOLTS
STARTER DRIVEN GEAR
WOODRUFF KEY
FLYWHEEL