Honda SH300 2006 Manual page 393

HYDRAULIC BRAKE
INSTALLATION
Install the rear brake pads (page 17-14).
REAR BRAKE CALIPER
Install the caliper to the swingarm so that the disc is
positioned between the pads, being careful not to
damage the pads.
Hold the caliper and install new brake caliper
mounting bolts then tighten them to the specified
torque.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
MOUNTING BOLTS
Connect the brake hose to the rear brake caliper
with the oil bolt and new sealing washers.
BRAKE HOSE
STOPPER
Tighten the brake hose oil bolt to the specified
torque while setting the hose joint against the stop-
per on the caliper body.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Fill brake fluid and bleed air the rear (combined)
brake line hydraulic system (page 17-10).
Install the following:
– brake hose protector (page 16-11)
– exhaust pipe/muffler (page 3-15)
OIL BOLT
SEALING WASHERS
17-35