Honda SH300 2006 Manual page 273

SERVICE INFORMATION
GENERAL
• The final reduction can be serviced with the engine installed in the frame.
• For final reduction oil level check and change (page 4-17).
• When installing the driveshaft, be sure to use the special tools; position the special tools against the bearing inner race
and pull the driveshaft into the bearing until it is fully seated.
SPECIFICATIONS
Final drive oil capacity
Recommended final drive oil
TORQUE VALUE
Final reduction case bolt
Sensor protector socket bolt
TOOLS
Case puller
07SMC-0010001
Bearing remover shaft
07936-KC10100
ITEM
After draining
After disassembly
24 N·m (2.4 kgf·m, 18 lbf·ft)
10 N·m (1.0 kgf·m, 7 lbf·ft)
Bearing remover head, 14 mm
07WMC-KFG0100
Bearing remover, 20 mm
07936-3710600
SPECIFICATIONS
0.28 liter (0.30 US qt, 0.25 lmp qt)
0.30 liter (0.32 US qt, 0.26 lmp qt)
Honda "4-stroke motorcycle oil" or an equivalent
API service classification: SG or higher
(except oils labeled as energy conserving on the circular
API service label)
Viscosity: SAE 10W-30
JASO T 903 standard: MA
ALOC bolt; replace with a new one
Bearing remover head, 15 mm
07936-KC10200
Bearing remover handle
07936-3710100
FINAL REDUCTION
12-3