Fuel Line Inspection - Honda SH300 2006 Manual

FUEL SYSTEM (PGM-FI)

FUEL LINE INSPECTION

FUEL PRESSURE RELIEVING/QUICK
CONNECT FITTING REMOVAL
• Before disconnecting fuel hose, relieve pressure
from the system as following procedures.
1. Turn the ignition switch "OFF".
Remove the luggage box (page 3-5).
Disconnect the fuel pump 5P connector.
2. Turn the ignition switch "ON".
3. Start the engine, and let it idle until the engine
stalls.
4. Turn the ignition switch "OFF".
5. Check the fuel quick connect fitting for dirt, and
clean if necessary.
Place a shop towel over the quick connect fitting.
6. Pull the rubber off the fuel feed pipe.
6-44
FUEL PUMP 5P CONNECTOR
QUICK CONNECT FITTING
RUBBER
FUEL FEED PIPE
SHOP TOWEL