Honda SH300 2006 Manual page 266

DRIVE AND DRIVEN PULLEYS/CLUTCH
ASSEMBLY
• Apply specified quantity of grease to the inside
of the driven face and the guide grooves in the
movable driven face.
• Avoid getting grease or oil on the clutch shoe lin-
ings and driven pulley faces. Discard contami-
nated clutch shoes and clean contaminated
pulley faces with a high quality degreasing
agent.
DRIVEN FACE
OIL SEAL
MOVABLE
DRIVEN FACE
DRIVEN PULLEY
Apply grease to new oil seal lips and outer surfaces,
and install them into the movable driven face.
Coat new O-rings with engine oil and install them
into grooves in the movable driven face.
11-16
E-CLIPS
GUIDE
ROLLER PINS
GUIDE
ROLLERS
SHOE
SPRINGS
OIL SEAL
O-RINGS
SIDE PLATE
CLUTCH SHOES
RUBBER
DAMPERS
SEAL COLLAR
SPRING COLLAR A
DRIVE PLATE
CLUTCH/DRIVEN
PULLEY NUT
79 N·m (8.1 kgf·m,
58 lbf·ft)
DRIVEN FACE SPRING
SPRING COLLAR B
SPRING SEAT
OIL SEALS
O-RINGS