Honda SH300 2006 Manual page 357

Table of Contents

REAR WHEEL/SUSPENSION

Install the rear brake caliper to the swingarm and

tighten the new rear brake caliper mounting bolts to

the specified torque.

TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)

Install the brake hose clamp to the swingarm and

tighten the bolt.

MOUNTING BOLTS

Install the brake hose protector to the swingarm and

tighten the bolts.

Tighten the rear axle nut to the specified torque.

TORQUE: 118 N·m (12.0 kgf·m, 87 lbf·ft)

Install the exhaust pipe/muffler (page 3-15).

REAR AXLE NUT

Measure the clearance (air gap) between the sensor

ABS type only.

and pulser ring at several points by turning the

wheel slowly.

It must be within specification.

STANDARD: 0.2 – 1.2 mm (0.01 – 0.05 in)

The sensor air gap cannot be adjusted.

If it is not within specification, check each installed

part for deformation, looseness and damage.

Chapters

Table of Contents