Honda SH300 2006 Manual page 473

LIGHTS/METERS/SWITCHES
REMOVAL/INSTALLATION
Remove the following:
2P CONNECTOR
– Front inner cover (page 3-10)
– Immobilizer (page 23-14)
Disconnect the ignition switch 2P connector.
Loosen the seat lock cable joint nut and disconnect
the seat lock cable from the ignition switch.
JOINT NUT
SEAT LOCK CABLE
Remove the ignition switch mounting bolts and
IGNITION SWITCH
ignition switch.
Install the ignition switch with new one-way bolts.
Tighten the ignition switch one-way bolts.
Install the removed parts in the reverse order of
Route the wires
removal.
and cable properly
(page 1-19).
BOLTS
22-17